Press the key until you see " OUT.MD".COM2 Output Mode set to "CMD" (output after a request command is received). The first change you need to make is to the following menu item: The indicator shows "CoNFG" to indicate that you are in Setup Menu mode. See section 8.1 of the Scale Service Manual for instructions on turning this switch ON. The configuration/calibration switch must be set in the ON position in order to make changes to specific parameters. All changes below are under the USER menu. Enter the Setup Mode on the scale and navigate the Setup Menu. You will need to ensure that the scale is set to the below settings, as they may vary from the Default Settings. This PDF document contains setup information for your scale. If your scale does not register the weight, you need to make changes to the default settings of the scale to work with StoreTender.ĭownload a copy of the Scale Service Manual for reference. SYNC your POS to accept the changes to the hardware (green button on main menu). Add weight to the scale and see if the scale registers. Save your changes and press the TEST button. Enter the settings as shown below, replacing the Port Name selection with the COM port you connected to. In StoreTender, navigate to Setup > Register > Devices > Scale. A USB cable connection is not supported.Ĭonnect your scale using the included serial cable to an available COM port on your PC. StoreTender supports the use of the Brecknell 67XXU POS Scale, when used with a serial cable.
0 kommentar(er)
